Stanley - Multi-Code - Linear
Model 3089 One Button Remote Control For
Garage Door Openers And Gate Operators
Multi-Code 308911 Features:

  • One Button Remote Control Transmitter
  • Molded design to comfortably fit the hand
  • Easy access to battery and dip switch
  • Stanley Electronics 300MHz compatible
  • Operates with all Multi-Code receivers and transmitters with 300MHz
  • Power: long-life 9 V battery included, Visor clip  also included
  • Frequency: 300 MHz, Codes: 1,024 (set by dip switches)
  • Dimensions: 3.75 x 2.5 x .875 inches
  • Programing Instructions
Multi-Code Remote Models 3089-11, MC308911, 308911 Garage Door Opener and Gate Remotes...
This Remote Works With All Multi-Code Remotes, Receivers and Keypad With 300MHz Frequency
Multi-Code 3089 11 By Linear 300MHZ
$15.95
The Model 308911 One button visor remote is a poratble transmitter designed for automatic garage door openers and gate operators.
This transmitter is a single-channel device, pressing the pushbutton will send a signal to the receiver to activate the next cycle.
The transmitter has a red test/operate indicator and is powered by a 9-volt battery which is included. A visor clip is also included.
The transmitter is Multi-Code format with one 10-position coding switch providing 1,024 possible codes.
The transmitter will only activate receivers set with the same code.
The Model 308911 is compatible with 300 MHz Multi-Code receivers and Linear Model 109950 and 302850 receivers.
Quick programing instructions for the Multi-Code 3089-11 remote control transmitter:

1. Open the old remote controls case, located the 10 two position switches, DO NOT CHANGE THE CODES POSITION.
2. Open the new remote controls case, locate the 10 two position switches.
3. Using a paper clip set the switches in the new remote to match the switch positions of the old remote.
4. Close the new remote control and press the button on the remote, it should operate the door or gate
5. Close the old remote and you should be all set.

The digital code can be matched to the companion built in receiver or external receiver by following the above procedure.
Use the motor unit receiver code settings for your new remote, instead of the old remote. TURN THE POWER OFF TO THE MOTOR UNIT 1ST.
Use the external receiver code setting inside the receiver to set the code. TURN THE POWER OFF TO THE MOTOR UNIT 1ST.
Turn the power back on when the codes are set.
$3.25
Extra Multi-Code 3089 11 Battery :
$2.95
Extra Multi-Code 3089 11 Battery :
$2.75
Monday - Friday Orders
Ship In 24 Hours!
Multi-Code® and Linear® are registered trademarks of the Linear Corporation. Stanley® is a registered trademark of the Stanley Corporation.
Copyrighted 2013 Multi-CoderRemotesOnline.com  |  All Payments Are In US Dollars Only  |  All Rights Reserved